Simulation of the injection moulding of EPDM: in this article Georg Hohl and Lothar H. Kallien describe the use and benefits of a 3-D simulated model, ... An article from: Plastics & Rubber Asia

This digital document is an article from Plastics & Rubber Asia, published by Plastics & Rubber Asia Ltd. on February 1, 2002. The length of the article is 1153 words. The page length shown above is based on a typical 300-word page. The article is delivered in HTML format and is available in your Amazon.com Digital Locker immediately after purchase. You can view it with any web browser.

Citation Details
Title: Simulation of the injection moulding of EPDM: in this article Georg Hohl and Lothar H. Kallien describe the use and benefits of a 3-D simulated model, taking as an example a moulding for a part that is built into the rear flap of the new Audi A2. (Simulation exercise).
Author: Georg Hohl
Publication:Plastics & Rubber Asia (Magazine/Journal)
Date: February 1, 2002
Publisher: Plastics & Rubber Asia Ltd.
Volume: 17 Issue: 108 Page: S14(2)

Distributed by Thomson Gale