Experimental investigation of adhesive meltblown web production using accessory air.: An article from: Polymer Engineering and Science

This digital document is an article from Polymer Engineering and Science, published by Thomson Gale on January 1, 2006. The length of the article is 2890 words. The page length shown above is based on a typical 300-word page. The article is delivered in HTML format and is available in your Amazon.com Digital Locker immediately after purchase. You can view it with any web browser.

From the author: Using a low-melting-point polymer, copolyamide, as raw material, adhesive meltblown webs were formed on the ordinary melt-blowing line by using the accessory air and the accessory air chamber. The webs thus produced exhibit narrower fiber diameter distribution and a more uniform pore structure. At the same time, four main melt-blowing parameters, the primary air pressure, the accessory air pressure, the melt throughput rate, and the die-to-collector distance, are discussed in terms of their influence on geometric mean diameter of fibers and fiber diameter distribution. POLYM. ENG. SCI., 46:1-7, 2006. [c] 2005 Society of Plastics Engineers

Citation Details
Title: Experimental investigation of adhesive meltblown web production using accessory air.
Author: Xiaomei Wang
Publication:Polymer Engineering and Science (Magazine/Journal)
Date: January 1, 2006
Publisher: Thomson Gale
Volume: 46 Issue: 1 Page: 1(7)

Distributed by Thomson Gale