This book synergistically integrates the design process with the specific commands and procedures of Pro|ENGINEER through a unique presentation scheme. Users are first provided with the design information about the part or assembly and its design intent. Then, they see the sequence of steps involved in modeling the part/assembly. Detailed instructions are provided in a four-column presentation showing goals, steps and commands. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts.
Table of Contents
1. Introduction
2. Bearings
3. Bearings
4. Bushing
5. Retaining Ring
6. Shaft
7. Shaft Drawing
8. Nuts and Bolts
9. Radial Plate Cam
10. Housing
11. Cam Assembly
12. Cam Follower Assembly
13. Washington Monument and Wing
14. Gateway Arch
15. Springs
16. Spur and Helical Gears
17. Axial Cam
18. Grooved Cam
19. Bolt Heads
20. Electrical Fuse Assembly
