Three-Phase Conversion: Running Three-phase Equipment on Single Phase Supplies (Workshop Practice)

A practical guide to running three-phase equipment on single-phase electricity supplies. Often, model engineers buy industrial workshop equipment, such as lathes, drilling machines and milling machines, which usually require a three-phase electricity supply. Although ready-built phase converters are available, they can often cost as much or even more than the equipment purchased. This book provides an invaluable source of practical guidance on how anyone can find out the type of electrical equipment they have, and how to convert it to run on a single-phase supply. The book provides calculations, step-by-step instructions with photographs and diagrams and covers electricity supplies in the UK, North America, Europe and the rest of the world. Finally, it also advises on which equipment cannot be converted at all.

• Unique3phase Master Book Edition 3
• Electric Motors (Workshop Practice)
• Electric Motors in the Home Workshop: A Practical Guide to Methods of Utilizing Readily Available Electric Motors in Typical Small Workshop Applications (Workshop Practice Series)
• Tool & Cutter Sharpening (Workshop Practice)
• Hardening, Tempering and Heat Treatment (Workshop Practice)
• Dividing (Workshop Practice)
• Milling: A Complete Course (Workshop Practice)
• Bearings (Workshop Practice)
• Lathework: A Complete Course (Workshop Practice)
• Gears & Gear Cutting (Workshop Practice Series 17)