Control of injection velocity using a fuzzy logic rule-based controller for thermoplastics injection molding.: An article from: Polymer Engineering and Science

This digital document is an article from Polymer Engineering and Science, published by Society of Plastics Engineers, Inc. on January 1, 1999. The length of the article is 4714 words. The page length shown above is based on a typical 300-word page. The article is delivered in HTML format and is available in your Amazon.com Digital Locker immediately after purchase. You can view it with any web browser.

From the supplier: Plastics manufacturing using an injection molding machine with the open-loop control technology are most likely to encounter differences in step change time. Injection velocity dynamics tend to become duller as the injection molding machine is further subjected to different molding conditions. As a solution, engineers have developed the closed-loop system using fuzzy logic to control injection velocity. However, the technology needs to be perfected since its installation necessitates the use of a cavity pressure transducer.

Citation Details
Title: Control of injection velocity using a fuzzy logic rule-based controller for thermoplastics injection molding.
Author: Hoi-Pang Tsoi
Publication:Polymer Engineering and Science (Refereed)
Date: January 1, 1999
Publisher: Society of Plastics Engineers, Inc.
Volume: 39 Issue: 1 Page: 3(1)

Distributed by Thomson Gale