Flatness and microstructure of a light guide plate fabricated by microinjection molding.(Report): An article from: Polymer Engineering and Science

This digital document is an article from Polymer Engineering and Science, published by Society of Plastics Engineers, Inc. on January 1, 2013. The length of the article is 2493 words. The page length shown above is based on a typical 300-word page. The article is delivered in HTML format and is available immediately after purchase. You can view it with any web browser.

From the author: This study photo-etches micropatterns on mold inserts and manufactures a light guide plate with microstructures using microinjection molding. The single parameter method is used to investigate flatness and replication with different process parameters for microinjection molding. Mold temperature is the most important factor for plate flatness and microstructure replication of a light guide plate fabricated by microinjection molding. Low mold temperature increases the flatness of light guide plates, whereas a high mold temperature improves height replication of the microstructure of light guide plates. Optimal mold temperature to maintain flatness and increase microstructure replication of light guide plates is 60[degrees]C. POLYM. ENG. SCI., 53:212-218, 2013. [c]2012 Society of Plastics Engineers

Citation Details
Title: Flatness and microstructure of a light guide plate fabricated by microinjection molding.(Report)
Author: Yun-Ho Lin
Publication:Polymer Engineering and Science (Magazine/Journal)
Date: January 1, 2013
Publisher: Society of Plastics Engineers, Inc.
Volume: 53 Issue: 1 Page: 212(7)

Article Type: Report

Distributed by Gale, a part of Cengage Learning