SuperSpeed Device Design By Example

This is a "How-To" book which explains, with hands-on examples, how to design and implement a SuperSpeed USB peripheral that can interface to your hardware using a 32-bit 100MHz bus with standard or custom protocols. The book is based on the Cypress FX3 SuperSpeed Device and the firmware examples are written around a low-cost SuperSpeed Explorer board and a companion CPLD board which are available from www.cypress.com/fx3book. The software examples are written for the Windows operating system and the CPLD examples are written in Verilog. The source code for all of the examples is downloadable from the book web site. If you currently think that SuperSpeed USB design is only for the elite then look inside this book and discover that SuperSpeed technology has now been made accessible to the rest of us!

• USB Complete: The Developer's Guide (Complete Guides series)
• USB Mass Storage: Designing and Programming Devices and Embedded Hosts
• USB Embedded Hosts: The Developer's Guide
• Programming FPGAs: Getting Started with Verilog
• Designing with Xilinx® FPGAs: Using Vivado
• Serial Port Complete: COM Ports, USB Virtual COM Ports, and Ports for Embedded Systems (Complete Guides series)
• RTL Modeling with SystemVerilog for Simulation and Synthesis: Using SystemVerilog for ASIC and FPGA Design