MakerFocus 10pcs NRF24L01+ 2.4GHz Wireless RF Transceiver Module Compatible with Ar duino Raspberry Pi
📄 Viewing lite version
Full site ›
11.99
USD
🛒 Buy New on Amazon 🇺🇸
Book Details
PublisherAllwish
ISBN / ASINB00O9O868G
ISBN-13978B00O9O8681
Sales Rank7,694
MarketplaceUnited States 🇺🇸
Description ▲
Specification:
* 100% Quality Guarantee;
* Model:NRF24L01;
* nRF24L01 is a single chip radio transceiver for
the world wide 2.4 - 2.5 GHz ISM band.
* The transceiver consists of a fully integrated
frequency synthesizer, a power amplifier, a
crystal oscillator, a demodulator, modulator and
Enhanced ShockBurst? protocol engine.
* Output power, frequency channels, and
protocol setup are easily.
* programmable through a SPI interface. Current
consumption is very low, only 9.0mA at an output
power of -6dBm and 12.3mA in RX mode.
* Built-in Power Down and Standby modes
makes power saving easily realizable.
* Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
Particularly suitable for industrial control
applications.
* 125 Communications channels, Multi-point
communication and frequency hopping to meet
the communication needs.
* Built-in hardware CRC error detection,
Multipoint communication address control.
* Low-power 1.9 ~ 3.6V, only 1uA on Power down mode.
* Built-in 2.4Ghz antenna.
* Available software to set the address, only
received local Address when output data(Provide
interrupt instruction), can be directly connected
to a variety of microcontrollers, Software
programming is very convenient.
* Support 6 Data channels of data reception.
* Standard DIP Pitch Interface for embedded applications.
You will get:
10 pieces of NRF24L01 + 2.4GHz RF Wireless
Transceiver Module
Please Note:
* Please check pictures for more details.
* Transceivers integrated module , transmit or
receive can not be simultaneously by one module.
* If you have any questions during use, please feel free to contact our service personnel. We will do our best to give you a satisfactory answer.
Similar Products ▼
- ELEGOO for Arduino Nano V3.0, Nano Board CH340/ATmega328P Without USB Cable, Compatible with Arduino Nano V3.0 (Nano x 3 Without Cable)
- Makerfocus 5pcs nRF24L01+ and ESP8266 ESP-01 Breadboard Breakout Adapter Board Common to Both
- kuman 3 pcs nRF24L01+PA+LNA Antenna Wireless Transceiver RF Transceiver Module for Arduino KY67
- Emakefun for Arduino Nano V3.0, Nano Board ATmega328P 5V 16M Micro-Controller Board with USB Cable (Pre-soldered Nano 5pcs)
- Elegoo EL-CP-004 120pcs Multicolored Dupont Wire 40pin Male to Female, 40pin Male to Male, 40pin Female to Female Breadboard Jumper Wires Ribbon Cables Kit for arduino
- WGCD 10pcs Joystick Breakout Module Game Controller for Arduino PS2
- Longruner Mini Nano V3.0 ATmega328P 5V 16M Micro Controller Board Module for Arduino
- Emakefun Nano Terminal Expansion Adapter Board for Arduino Nano V3.0 AVR ATMEGA328P with NRF2401+ Expansion Interface, DC Power Supply Interface (5PCS)
- SenMod 5PCS Micro SD Card Micro SDHC Mini TF Card Adapter Reader Module for Arduino
- Longruner Mini Nano V3.0 ATmega328P 5V 16M Micro Controller Board Module for Arduino (10Pcs)