STEPPERONLINE Nema 17 Stepper Motor Bipolar 2A 59Ncm(84oz.in) 48mm Body 4-lead W/ 1m Cable and Connector compatible with 3D Printer/CNC

This is an updated version nema 17 stepper motor with holding torque of 59Ncm(83.6oz.in). Based on old verstion, we have lengthened motor cable length to 1 metre, and add a 4-pin 0.1" pitch (2.54mm) Harwin female connector at the end of cable. It's good ideal for 3D printers, as well as CNC and robotics applications.

Important notice: Some customers reported they bought this model from other seller under this listing, but found much of difference with our description(no connector and shorter leads). We highly recommend you report this problem to Amazon if you have same experience. If you are a new buyer, please pay attention to our ID is "STEPPERONLINE", and our P/N is "17HS19-2004S1".

Electrical Specification:

* Manufacturer Part Number: 17HS19-2004S1
* Motor Type: Bipolar Stepper
* Step Angle: 1.8 deg.
* Holding Torque: 59Ncm(83.6oz.in)
* Rated Current/phase: 2.0A
* Phase Resistance: 1.4ohms
* Inductance: 3.0mH+/-20%(1KHz)

Physical Specification:

* Frame Size: 42 x 42mm
* Body Length: 48mm
* Shaft Diameter: 5mm
* Shaft Length: 24mm
* D-cut Length: 15mm
* Number of Leads: 4
* Lead Length: 1m with connector
* Weight: 390g

Connection:

Black(A+), Green(A-), Red(B+), Blue(B-)

Warning:

Make sure the motor connect to a constant current or chopper drive controller before you test motor.
Connecting the motor directly to a power supply will destroy the motor.

• WINOMO Nema 17 Stepper Motor Mounting Bracket w/ M3 Screws 2 Pack
• ELEGOO Stepstick Stepper Motor Driver Module A4988 + Heat Sink for 3D Printer Reprap, CNC Machine or Robotics(Pack of 5)
• BIQU A4988 Compatible Stepper StepStick Motor Diver Module with Heat Sink for 3D Printer Controller Ramps 1.4(Pack of 5pcs)
• Stepper Motor Mounting Bracket, 3PCS Alloy Steel L Bracket for Nema 17 Stepper Motor with Screws and Inner Hexagon Spanner
• Adafruit Motor/Stepper/Servo Shield for Arduino v2.3 Kit
• GT2 Timing Belt Pulley, 8pcs 5mm 20 Teeth Timing Pulley Wheel and GT2 5 Meters Rubber 2mm Pitch 6mm Wide Timing Belt with Allen Wrench for 3D Printer CNC by Beauty Star
• KINGPRINT DRV8825 Stepper Motor Driver Module with Heat Sink for 3D Printer Rrerap Ramps 1.4 A4988 (Pack of 5pcs)
• kuman CNC Shield Expansion Board V3.0 +UNO R3 Board + A4988 Stepper Motor Driver with Heatsink for Arduino Kits K75 (CNC Shield+UNO R3+Stepper Motor)
• Qunqi 5packs Aluminum GT2 Timing Belt Pulley 16 Teeth Bore 5mm Width 6mm and Wrench for RepRap 3D Printer Prusa i3 + Allen Key
• DROK 5PCS Aluminum GT2 Timing Belt Pulley 16 Teeth Bore 5mm Width 6mm and Wrench for RepRap 3D Printer Prusa i3