kuman 10pcs nRF24L01+ 2.4GHz Antenna Wireless Transceiver RF Transceiver Module Arduino Raspberry Pi Compatible K19

Introductions:
The Addicore nRF24L01 is a 2.4GHz ISM band transceiver.
The transceiver consists of a fully integrated frequency synthesizer, a power amplifier, a crystal oscillator, a demodulator, modulator and enhanced ShockBurst, protocol engine.
A host microcontroller can communicate and configure the nRF24L01+ over a 4-pin Serial Peripheral Interface (SPI). The configuration registers are accessible through the SPI connection.
Configurable parameters include frequency channel (125 selectable channels), output power, and data rate (data rates: 250kbps, 1Mbps, and 2Mbps).
The module has 5V tolerant inputs which allows for direct connection of SPI pins to the Arduino.
Internal filtering results in high margins of meeting RF regulatory standards. The module's radio uses Gaussian Frequency-Shift Keying (GFSK) modulation as well as fast Automatic Gain Control (AGC)

Feature
Ultra small: 15x29mm (including:built-in 2.4GHz antenna),for easy implementation into designs without additional hardware.
Low power consumption: Ultra low power consumption as low as 11.3mA transmitting, 13.5mA receiving at 2Mbps, 900nA in power down, and 26uA in standby.
Low operating voltage: 1.9 ~ 3.6V When using the nRF24L01 with an Arduino be sure to use the 3.3V output pin from the Arduino board to power the nRF24L01+ module
Communication range: 262 feet (80 meters) in ideal conditions.
Multi-channel:support six channels data reception.
Fast data transfer rate: 2Mbps (software setting range: 1Mbps or 2Mbps)
Multi frequency points:125 frequency points to meet the needs of multi point communication and frequency hopping communication.
The maximum transmit power:0dBm

Product Contents:
10 pieces nRF24L01 modules
10*14mil thick resealable clear plastic bag

• Makerfire 4pcs NRF24L01+ Breakout Adapter with on-board 3.3V Regulator for NRF24L01+ Wireless Module
• ELEGOO for Arduino Nano V3.0, Nano Board CH340/ATmega328P Without USB Cable, Compatible with Arduino Nano V3.0 (Nano x 3 Without Cable)
• Makerfocus 5pcs nRF24L01+ and ESP8266 ESP-01 Breadboard Breakout Adapter Board Common to Both
• Longruner Mini Nano V3.0 ATmega328P 5V 16M Micro Controller Board Module for Arduino (10Pcs)
• UCEC XY-MK-5V / XY-FST 433Mhz Rf Transmitter and Receiver Module Link Kit for Arduino/Arm/McU/Raspberry pi/Wireless DIY(6-pack)
• Elegoo MEGA 2560 R3 Board ATmega2560 ATMEGA16U2 + USB Cable for Arduino RoHS Compliant
• MakerFocus 4pcs ESP8266 ESP-01 Serial Wireless WiFi Transceiver Receiver Module 1MB SPI Flash DC3.0-3.6V Internet of Things WiFi Module Board Compatible with Arduino
• ELEGOO UNO R3 Board ATmega328P ATMEGA16U2 with USB Cable for Arduino RoHS Compliant
• Gikfun USB Nano V3.0 ATmega328 CH340G 5V 16M Micro-Controller Board for Arduino (Pack of 3pcs) EK1620x3
• ELEGOO 120pcs Multicolored Dupont Wire 40pin Male to Female, 40pin Male to Male, 40pin Female to Female Breadboard Jumper Wires Ribbon Cables Kit for arduino