HiLetgo BME280 Atmospheric Pressure Sensor Temperature Humidity Sensor Breakout for Arduino

Description:
BME280, the precision sensor from Bosch, is soldered onto PCB. Not only the pressure and the temperature, this sensor can measure humidity.
It uses both I2C and SPI (supports 3-, 4-wire SPI) interface
Make sure to put SDO to high to get address 0x77. This will work with Adafruit BME280 library perfectly.

Specifications:
Supply Voltage: 1.8 - 5V DC
Interface: I2C (up to 3.4MHz), SPI (up to 10 MHz)
Temperature: -40 to +85°C
Humidity: 0-100%
Pressure: 300-1100 hPa
Temperature: 0.01°C
Humidity: 0.008%
Pressure: 0.18Pa
Temperature: +-1 Humidity: +-3%
Pressure: +-1Pa
I2C address
SDO LOW 0x76
SDO HIGH£ 0x77

Package included:
1* BME280 Atmospheric Pressure Sensor Temperature Humidity Sensor Breakout

• HiLetgo ESP-WROOM-32 ESP32 ESP-32S Development Board 2.4GHz Dual-Mode WiFi + Bluetooth Dual Cores Microcontroller Processor Integrated with Antenna RF AMP Filter AP STA for Arduino IDE
• HiLetgo 2pcs ESP8266 NodeMCU LUA CP2102 ESP-12E Internet WiFi Development Board Open Source Serial Wireless Module Works Great with Arduino IDE/Micropython (Pack of 2PCS)
• MakerFocus Heart-Rate Sensor Module, MAX30102 Blood Oxygen Sensor, Compatible with Arduino STM32
• Gowoops 2 PCS DHT22 Temperature Humidity Sensor Module Digital Measurement for Arduino Raspberry Pi 2 3
• MakerFocus 2pcs I2C OLED Display Module 0.91 Inch I2C SSD1306 OLED Display Module Blue I2C OLED Screen Driver DC 3.3V~5V for Arduino
• CHENBO 5 PCS BMP280 3.3 Digital Barometric Pressure Altitude Sensor High Precision Atmospheric Module
• HiLetgo ESP32 OLED WiFi Kit ESP-32 0.96 Inch Blue OLED Display WiFi+Bluetooth CP2012 Internet Development Board for Arduino ESP8266 NodeMCU
• Adafruit BME280 I2C or SPI Temperature Humidity Pressure Sensor
• Diymore Digital Breakout BME280 Temperature Humidity Barometric Pressure Sensor Module with IIC I2C for Arduino
• Adafruit BMP280 I2C or SPI Barometric Pressure and Altitude Sensor