8 AA Battery Holder with Snap Connector 12V / 9.6V by Corpco

Great 8 AA battery holder for your Arduino project! Provides 12V output when used Alkaline batteries, 9.6V when used with rechargeable AA batteries. These AA battery holders feature a standard 9V snap connector. The case is made from ABS plastic with nickel plated springs to hold your AA batteries in place. Each battery holder measures 2.5" x 2.3" x 1.25"( L * W * H ). AA batteries in these holders will last much longer than a standard 9V battery will when powering up electronic projects. AA batteries not included. These battery holders will also replace the holders in many different electronics devices that may have been damaged by corrosion.

• 5pack 9v Battery Clip with 2.1mm X 5.5mm Male DC Plug for Arduino by Corpco
• 5pack 9v Battery Clips with bare leads by Corpco
• Philmore Battery Holder for (6) AA with Standard Snap Connector : BH363 (1)
• Hilitchi 2Set 6 x AA Thicken Battery Holder and T Type Wired Battery Clip Standard Snap Connector
• Mosuch Battery Holder for (8) AA with Standard Snap Connector : BH383 (1)
• Pangda I Type Long Cable Connection Hard Shell Black Red 9 V Battery Clip Connector Buckles 8 Pack
• Hilitchi 2Set 8 x AA Thicken Battery Holder and T Type Wired Battery Clip Standard Snap Connector
• IDS Faux Leather Housing T Type Clip Connector for 9V Battery
• BBTO 10 Pack T Type 9 V Battery Clip Connector Long Cable Connection Hard Shell Black Red Connector
• CO RODE 8 x AA 12V Battery Holder Case Box Wired ON/OFF Switch w Cover Pack of 2