[8-PACK] LM2596 DC-DC Adjustable Buck Converter 3-40 V to 1.5-35v Step Down Power Supply High Efficiency Voltage Regulator Module …

Product Features

Parameters:
Input Voltage: DC 3 -40 V
Output Voltage: DC 1.5 - 35 V
Output Current: 3A(MAX) It is recommended to use under 2A (NOTE: When using high power, add a heat sink to the power supply chip)
Load adjust ratio: +/-0.5% 
Voltage adjust ratio: +/-2.5% 
Transferring efficiency: 92% Max(the higher output voltage, the higher efficiency) 
ON/OFF frequency: 150KHz 
Output ripple: 200mV 
Module feature: buck and non-isolated 
Rectification method: non-synchronous rectification 
Size: 5.4x2.3x1.8CM 
Weight: 16g 

Fuction:
1.Built in over-temperature protection function 
2.Built in current limit function 
3.Built in output short-circuit protection function 

How to use
1.Access the power supply ( 3 -40 V), the power indicator light, the module is working properly.
2.Adjust the blue potentiometer knob (usually clockwise rotation boost, counterclockwise rotation Step-down) and monitor the output voltage with a multimeter to reach the required voltage. 
3.A customer reflects the module output voltage can not be adjusted, always equal to the input voltage. When you encounter this problem, please first counterclockwise rotation potentiometer 10 laps above, and then use the module can be normal adjustment of the voltage.

Package includes: 
8X LM2596 board
8 pieces of heat sink

• MakerFocus 5pcs Mini Digital DC Voltmeter 0.28 Inch Two-Wire 2.5V-30V Mini Digital DC Voltmeter Voltage Tester Meter 5 Colours
• Black Menba 3 Sets XT60 Parallel Battery Connector Cable for RC Multicopter Quadcopter
• bayite 3 Wire 0.36" DC 0~30V Digital Voltmeter Gauge Tester Red LED Display Panel Mount Car Motorcycle Battery Monitor Volt Voltage Meter Pack of 5
• eBoot Mini MP1584EN DC-DC Buck Converter Adjustable Power Step Down Module 24V to 12V 9V 5V 3V, 6 Pack
• bayite 3 Wire 0.36" DC 0~30V Digital Voltmeter Gauge Tester Blue LED Display Panel Mount Car Motorcycle Battery Monitor Volt Voltage Meter with Reverse Polarity Protection Pack of 5
• Icstation TP4056 Micro USB 5V 1A 18650 Lithium Battery Charger Board, with Overcharge Over-Discharge Over-Current Protection (Pack of 10)
• ELEGOO for Arduino Nano V3.0, Nano Board CH340/ATmega328P Without USB Cable, Compatible with Arduino Nano V3.0 (Nano x 3 Without Cable)
• AUSTOR 100 Pcs PCB Board Kit Including 30 Pcs Double Sided Prototype Boards and 30 Pcs 40 Pin 2.54mm Male and Female Header Connector(Bonus: 10 Pcs 2P&3P Screw Terminal Blocks and 30 Pcs Jumper Caps)
• Makerfocus 5pcs nRF24L01+ and ESP8266 ESP-01 Breadboard Breakout Adapter Board Common to Both
• 10pcs JacobsParts Mini360 3A DC Voltage Step Down Power Converter Buck Module 3.3V 5V 9V 12V