CCENT ICND1 100-105 Network Simulator

The most effective router and switch simulator for hands-on CCENT skills enhancement.

CCENT ICND1 100-105 Network Simulator helps you develop and improve hands-on configuration and troubleshooting skills without the investment in expensive lab hardware. This state-of-the-art, interactive simulation software enables you to practice your networking skills with more than 250 structured labs designed to help you learn by doing, the most effective method of learning.

Experience realistic network device responses as you perform each lab, which include detailed instructions, topology diagrams, critical-thinking questions, hints, and answers. Working through the labs, you will quickly become proficient with all the common Cisco IOS version 15 router and switch commands on the CCENT

exam. Unlike other simulators on the market, the lab scenarios included in the CCENT ICND1 100-105 Network Simulator are far more complex, challenging you to learn how to perform real-world network configuration and troubleshooting tasks.

Master the hands-on skills needed to succeed on the CCENT exam, including:

Router and switch navigation and administration

Ethernet LAN switches

VLANs, trunking, and switch security

Connected and static routes

RIPv2 configuration and verification

Access Control Lists (ACL)

NAT, syslog, and NTP configuration

IPv4 and IPv6 addressing and subnetting

Network troubleshooting

CCENT ICND1 100-105 Network Simulator includes four different types of labs and over 3,000 hands-on tasks that help you build the skills needed to succeed on the exam and in the real world.

Skill Builder labs are narrowly focused, enabling you to practice your configuration skills on a single topic. Coverage includes:

Router and switch CLI navigation

Interface status, ping, and traceroute

Configuring IP addresses and DHCP servers

VLAN and trunking configuration

Switch security

Connected, static, and default routes

RIPv2 configuration and verification

ACL analysis and configuration

NAT configuration

Syslog and NTP configuration

Subnetting Exercises labs help you to perform subnetting calculations quickly and accurately, a critical skill for

success on the CCENT exam. Topics covered include:

IPv4 and IPv6 subnet ID calculation

IP address rejection

IP route selection

VLSM overlaps

IPv6 EUI-64 calculation

Selecting VLSM routes

Configuration Scenario labs are more broadly focused, combining multiple technologies into configuration scenarios that mimic real-world environments. These labs are longer and more complex, challenging you to put your configuration skills to the test. Topics covered include:

Network fundamentals and administration

IP addressing

Static and default routing

RIPv2 configuration

Standard and extended ACLs

NAT configuration

Troubleshooting Scenario labs present typical troubleshooting scenarios and require you to explore the misconfigured network, isolate the issues, and correct the problems. These are very complicated and

realistic scenarios that truly test your ability to perform the job of a network engineer. Topics covered include:

Switch forwarding

VLAN troubleshooting

Path analysis

Port security

Network discovery

IP addressing and routing

DHCP server troubleshooting

NAT

Windows 10 (32/64-bit), Windows 8.1 (32/64-bit), or Windows 7 (32/64-bit)

1 gigahertz (GHz) or faster 32-bit (x86) or 64-bit (x64) processor

1 GB RAM (32-bit) or 2 GB RAM (64-bit)

16 GB available hard disk space (32-bit) or 20 GB (64-bit)

DirectX 9 graphics device with WDDM 1.0 or higher driver

Adobe Acrobat Reader version 8 and above

Mac system requirements (minimum):

macOS 10.12, 10.11, 10.10, or 10.9

Intel core Duo 1.83 GHz

512 MB RAM (1 GB recommended)

1.5 GB hard disk space

32-bit color depth at 1024x768 resolution

Adobe Acrobat Reader version 8 and above