Modeling with Pro/Engineer Wildfire 2.0

This book synergistically integrates the design process with the specific commands and procedures of Pro|ENGINEER through a unique presentation scheme. Users are first provided with the design information about the part or assembly and its design intent. Then, they see the sequence of steps involved in modeling the part/assembly. Detailed instructions are provided in a four-column presentation showing goals, steps and commands. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts.

Table of Contents

1. Introduction
2. Bearings
3. Bearings
4. Bushing
5. Retaining Ring
6. Shaft
7. Nuts and Bolts
8. Bolt Heads
9. Washington Monument and Wing
10. Springs
11. Axial Cam
12. Radial Plate Cam
13. Grooved Cam
14. Gateway Arch
15. Spur and Helical Gears
16. Shaft Drawing
17. Housing
18. Cam Assembly
19. Cam Follower Assembly
20. Electrical Fuse Assembly