Simulation of the injection molding process with a special capillary rheometer.: An article from: Rubber World

This digital document is an article from Rubber World, published by Lippincott & Peto, Inc. on July 1, 1994. The length of the article is 3568 words. The page length shown above is based on a typical 300-word page. The article is delivered in HTML format and is available in your Amazon.com Digital Locker immediately after purchase. You can view it with any web browser.

From the supplier: An experiment was conducted to determine the accuracy of laboratory tests when evaluating the injection molding process. The time to inject the mold and the amount of filling were tested. Four rubber compounds of varying viscosities were evaluated on three different machines. A Rheovulkameter and two production machines were utilized. All three machines produced the same results. Further experimentation will be needed utilizing different compounds.

Citation Details
Title: Simulation of the injection molding process with a special capillary rheometer.
Author: Hagen Kramer
Publication:Rubber World (Magazine/Journal)
Date: July 1, 1994
Publisher: Lippincott & Peto, Inc.
Volume: v210 Issue: n4 Page: p24(6)

Distributed by Thomson Gale