Measurement of the vapor phase deposition of polychlorinated bipheyls (PCBs) using a water surface sampler [An article from: Atmospheric Environment]

This digital document is a journal article from Atmospheric Environment, published by Elsevier in 2005. The article is delivered in HTML format and is available in your Amazon.com Media Library immediately after purchase. You can view it with any web browser.

Description:
A water surface sampler (WSS) was employed in combination with greased knife-edge surface deposition plates (KSSs) to measure the vapor phase deposition rates of PCBs to the sampler at an urban site, Chicago, IL. This sampler employed a water circulation system that continuously removed deposited PCBs. Total (gas+particle) and particulate PCB fluxes were collected with the WSS and KSSs, respectively. Gas phase PCB fluxes were then calculated by subtracting the KSS fluxes (particulate) from the WSS fluxes (gas+particle). The calculated gas phase PCB fluxes averaged 830+/-910ngm^-^2d^-^1. This flux value is, in general, higher than the fluxes determined using simultaneously measured air-water concentrations in natural waters and is in the absorption direction. This difference is primarily because the PCBs were continuously removed from the WSS water keeping the water PCB concentration near zero. Concurrently, ambient air samples were collected using a modified high volume air sampler. The gas phase PCB concentrations ranged between 1.10 and 4.46ngm^-^3 (average+/-SD, 2.29+/-1.28ngm^-^3). The gas phase fluxes were divided by the simultaneously measured gas phase ambient concentrations to determine the overall gas phase mass transfer coefficients (MTCs) for PCBs. The average gas phase overall MTCs (K"g) for each homolog group ranged between 0.22 and 1.32cms^-^1 (0.54+/-0.47cms^-^1). The average MTC was in good agreement with those determined using similar techniques.