(2 pack) 3 way socket replacement for lamp, Medium Base Interior Only, Incandescent Lamp holder, Removable Turn Knob, 2-Circuit.

Have you found yourself replacing lamps or over paying for a simple socket change?

Do you want to save time and money?

Then you've come to the right place!

ESC inc. has been in the repair industry for over 30 years!

We'll guide you through this simple process so that you never have to replace your lamps or over pay for a socket change again!

Easy 5 step process to install

1. On the right side of socket housing by the switch (Press) into housing to release outer shell, in some cases you will need to press back of housing as well. (Use a flat head screw driver)

2. Remove inner socket from housing DO NOT remove cardboard insulation.

3. With a flat head or Philips screw driver unscrew both bottom screws with the copper wire wrapped around them.

4. Keep copper wire tightly wrapped together and wrap them around replacement ESC socket bottom screws and tighten them down. There is no difference between screws don't worry about interchanging wires on them.

5. Press inner socket firmly into place in the earlier removed housing, screws with wire must be pressed all the way inside and should not be showing, then push housing and socket back into place on the original base that it was earlier removed from.

-Don't forget your bragging rights here, or with friends and family!-

Now Get Yours Before We Run Out Of Stock!

Just Click "Add To Cart"