LAMPVPATH 3 Pcs 4 x 1.5V (6V) AA Battery Holder with 3 Pcs 9V I Type Snap Connector Plastic Housing

Brand Name: LAMPVPATH

Specification:
Battery Type: 4 x 1.5V (6V) AA Batteries
Color: Black
Body Size : 6 x 6.3 x 1.6cm/2.36" x2.48" x0.63 "(L*W*H);
9V Snap Connector Size( Each ) :2.4 x 1.3 x 1cm/0.94" x 0.51" x 0.39" with wire length 14cm/5.5"
Construction:One layer can load 4 AA batteries
Material:plastic ABS
Weight: 15g(one 4aa battery holder and one 9V battery connector)

Package included:
(3 Pcs) 4-slots AA Battery Case Holders with (3 Pcs) 9V I Type Snap Connector Plastic

• LAMPVPATH 3 Pcs 4 x 1.5V (6V) AA Battery Holder with 3 Pcs 9V I Type Snap Connector Plastic Housing Two Layers Battery Case
• Ogrmar On/Off Switch 4 x 1.5V AA Battery Case Holder Leads Black w Cap 2Pcs
• 3Pcs 4/6/8 X 1.5V AA Battery Holder with Standard Snap Connector
• CO RODE 8 x AA 12V Battery Holder Case Box Wired ON/OFF Switch w Cover Pack of 2
• Hilitchi 2Set 6 x AA Thicken Battery Holder and T Type Wired Battery Clip Standard Snap Connector
• OSOYOO 10PCS IR Infrared Obstacle Avoidance Sensor Module for Arduino Smart Car Robot
• Haitronic 120pcs 20cm Length Jumper Wire/Dupont Cable Multicolored(10 Color) 40pin M to F, 40pin M to M, 40pin F to F for Prototype Breadboard/Arduino/DIY/Raspberry Pi/Orange pi Robot Ribbon Cables
• Qunqi L298N Motor Drive Controller Board Module Dual H Bridge DC Stepper For Arduino
• Hilitchi 2set Thicken Battery Holder for 4 x AA with Standard Snap Connector and Hard Plastic Housing T Type Wire
• Philmore Battery Holder for (4) AA with Standard Snap Connector : BH341